Install Propellers - xCraft X PlusOne Quick Start Manual

2. Install Propellers:

1. Place the bottom half of the spinner onto the motor then set the propeller over it.
2. Attach the clockwise spinning propellers (R) onto the top and bottom pylon motors and the
counterclockwise spinning propellers (no R) onto the wing motors. Ensure writing is facing up.
3. Screw the cap of the spinner on top of the propeller.
4. Tighten the spinner by holding the propeller stationary and rotating the spinner clockwise with
a thin metal rod or hex wrench inserted into the hole in the top of the spinner. Ensure that
spinners are tightened securely.
clockwise
propeller
hold stationary
(R)
counterclockwise
propeller
ensure
writing is
facing up
rotate clockwise
spinner
clockwise
propeller
(R)
counterclockwise
propeller