Advertisement
X PlusOne Quick Start Guide
1. Install Pylons:
1. Connect the pylon wires to the wires in the top of the wing as shown below. Connect two
Caution: Ensure wire polarity is correct or damage will result. Verify that all colored
wires on wing match with the corresponding colored wires on pylon. ESC should
bullet connectors and single ESC wire. Ensure polarity is correct (red to red, black to black, etc).
bullet
connectors
2. Insert the pylon spars into the connector on the wing and slide the pylon onto the wing. As you
slide the pylon in place, bundle the wires into the cavities in the wing and pylon.
connector
pylon spars
3. Insert pylon mounting screws as shown above: short screws on top, mid-length screws with
washer on side. Screws should be pushed in then tightened easily. If there is resistance, "hug"
the pylon to the craft by placing the motor mount in the pit of your arm and pressing the
connector from the other side with your hand, squeezing the pylon into place and aligning the
screw with the hole.
4. Install the second pylon onto the bottom of the wing by repeating steps 1 through 3.
connect smoothly.
ESC pylon
ESC wing
wire
wire (green
or yellow)
Advertisement
