First Flight - xCraft X PlusOne Quick Start Manual

Auto (set via Mission Planner(PC) or
QGroundControl(MAC))
Guided (Set via Mission Planner(PC) or
QGroundControl(MAC))
Follow Me (Ground station with GPS
required)

First Flight:

Perform preflight inspection.
1. Place X PlusOne on flat, level surface with the GPS antenna side facing you.
2. Check that the pylons are properly installed onto the wing
3. Check for loose parts or wires
4. Check foam and plastic components for signs of damage
5. Check that propellers are tight and installed to rotate in the proper direction
6. Power on transmitter (All switches need to be in the 'up' position and throttle down).
7. Install battery by facing the battery wires down and running the cable along the length of the
battery compartment, underneath the battery (see picture). Connect power to the craft by
matching the yellow ends of the both power cords together. The power cords will connect one
way. The battery balance cable is left loose.
8. Press and hold safety button, next to battery compartment, until it is solid red (If it does not
turn solid red, please disconnect the battery and restart the process). Indicator LED in the
center of the wing, should be flashing green; at connection of pylon.
red safety button
9. Put the battery cover on the battery compartment to enclose the battery and all wires.
will maintain its current attitude and will not return to
level. Acro mode is useful for forward flight, aerobatics
such as flips or rolls, or FPV when smooth and fast
control is desired.
Autonomous mission
X PlusOne will fly the flight plan saved to the autopilot
Ground station controlled flight
X PlusOne will fly to waypoints sent from the ground
station in real time
Follows ground station
X PlusOne will follow the ground station as you move.
Install "3DR Services" and "Tower" apps on smartphone
to connect with craft.
battery balance cable
battery power cord
craft power cord