From 1-Sided Originals To 2-Sided Copies Using Saddle Stitch (Booklet) - Panasonic DP-C213I Operating Instructions Manual

From 1-Sided Originals to 2-Sided Copies using Saddle Stitch
(Booklet)
The 2-Sided original cannot be copied into a booklet.
Originals should be placed on the ADF. (5.5" x 8.5" or 8.5" x 11" size is only available, up to 40 originals)
Saddle stitch binding is possible only when the optional 1-Bin Saddle Finisher (DA-FS325) is installed.
Ledger (11" x 17"), and Letter-R (8.5" x 11") are the only applicable paper sizes.
The standard setting for the copy size is the reduced size, however, the setting can be changed to a "original
size". Refer to Copier Settings in the Operating Instructions (For Function Parameters) on the provided CD-
ROM.
When the Fold Position is not matched with center position of the copies, set the binding margin. Refer to
General Settings (For Key Operator) in the Operating Instructions (For Function Parameters) on the provided
CD-ROM.
Stamping can be combined with the Booklet For Copying with Stamping, refer to Copying with Stamping (see
page 61-69).
1
Select "2-Sided / Original->Copy",
and then select "Booklet".
To display this screen, refer to steps 1 to 3 of
Basic Operation for the 2-Sided Copy
Mode (see page 40).
2
Select a bind position.
Select when binding the left
side, or the top side of the
page.
Select when binding the
right side, or the bottom
side of the page.
3
Select the cover page type if
necessary.
1 Select "Cover".
Continue on the next page...
43