Installation Instructions; Range Location; Cabinet Opening; Minimum Clearances To Combustible Surface - Amana AGDS901 Service Manual

Installation Instructions

Range Location

Choose a location based on following factors.
• Range is designed to be vented outdoors.
• Electrical rating is 12.5 KW, 120, 60 Hz.
• Drafts caused by home heating and air conditioning
and open doors or windows can disrupt ventilation air
pattern. Range should not be installed near windows
or doors.
• Range can not be installed in a tunnel type wall
opening. Air currents moving through tunnel can
disrupt ventilation air pattern.
• Range can either be ducted through wall or through
floor to outside.
• Make sure there is adequate space for proper
installation.
• Carefully read all instructions before beginning
installation.
Remove protective packing materials from range. Tape
residue can be cleaned with a soft cloth and alcohol.

Cabinet Opening

!
WARNING
To avoid risk of burns or fire by reaching over burners,
cabinet storage space located above range should be
avoided.
Range should extend approximately 1
cabinet front to oven door handle. Remove venting kit
from storage drawer. Using dimensions in figure below
and shown in Special Countertop Conditions section to
prepare cabinet opening.
Standard Cabinet and Countertop Height
1"
Range Dimensions:
WIDTH - 29 15 / inches
16
DEPTH - 29 inches (with handle)
HEIGHT - 36 inches
RS2310003 Rev. 1
1
/ inch from
2
Wall
35"
8
Minimum Clearances to Combustible
Surfaces
• Minimum clearance to rear wall is 0 inches.
• Minimum clearance to a vertical right or left side wall
is 3 inches.
• Minimum clearance to countertop/cabinet on each
side is 0 inches.
• Minimum of 30 inches between top of cooking surface
and bottom of an unprotected wood or metal cabinet.
30"
min.
13"
max.

Special Countertop Conditions

Irregular Cabinet and Countertop Heights such as
ceramic tile tops cause cabinet and countertop to be
higher than 36 inches. Follow instructions below when
countertop is higher than 36 inches.
1. Raise leveling legs to maximum level.
2. Measure from floor to side trim. If measurement is
less than height of countertop, floor must be
shimmed.
3. Shim floor using a piece of plywood same size as
range opening. Secure plywood to floor. Plywood
must be as secure as original flooring.
4. Install anti-tip bracket and slide range into place.
Island or Peninsula Installation
Island or peninsula installations with 24 inches deep
base cabinets must use flush back cabinets with no rear
toe space to avoid range interference. If a rear toe
space is desired, use 27 inches or deeper base cabinets.
3"
both
sides
18"
30 1/8"