Jump-Starting - BMW F 800 GS Adventure Rider's Manual

8
108
Place air filter cover 2 in posi-
tion, easing the side trim pan-
els out slightly to do so.
Install screws 1.
z
Install two screws 1 on left and
right.
Install centre trim panel
( 106).

Jump-starting

The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
vehicle electronics.
Do not use the on-board socket
to jump-start the engine of the
motorcycle.
A short-circuit can res-
ult if the crocodile clips
of the jump leads are accident-
ally brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the vehicle
electronics.
Make sure that the battery of the
donor vehicle has a voltage rating
of 12 V.
Remove centre trim panel
( 106).
When jump-starting the engine,
do not disconnect the battery
from the on-board electrical
system.
Begin by connecting one end
of the red jump lead to the
positive terminal of the dis-
charged battery and the other
end to the positive terminal of