Makita LS0814 Instruction Manual page 13

1. Adjusting screw
1. Motor unit
1. Lever
1. Lever
2. Clamping screw
3. Turn the adjusting screw counterclockwise for fine adjustment so that the
006966
tool moves in such a direction as the motor unit becomes upright.
1
006967
1
4. After fine-adjusting, tighten the lever firmly.
006968
Eg. When setting for left 30° bevel angle cutting
(1)
(2)
(3)
1
(4)
Fine adjusting for right bevel angle
006969
Refer to the sections titled "Mini sub fence" and "Adjusting the bevel angle".
1. Loosen the lever. At this time, make sure that the clamping screw is loos-
ened. If not, loosen it.
1
2
Loosen the lever.
Set the tool so that the pointer points to left bevel angle increment
greater by 1° - 2° than 30° on the bevel scale. Then tighten the
clamping screw clockwise.
Turn the adjusting screw counterclockwise for fine adjustment until
the pointer points to 30°.
Tighten the lever firmly.
13