Table of Contents
Advertisement
TROUBLESHOOTING
Problem
I do not know the
version number of
the firmware for the
P-touch.
When an error message appears on the display
When an error message appears on the display, follow the directions
provided below:
Message
請檢查已輸入 # 數位 ! The number of digits entered in the barcode data does not
裁刀出錯！
標籤超過最大長度！
內容已超過標籤長度
系統錯誤 xx!
查無此碼 !
51
When an error message appears on the display
• The version number and other information for the
firmware can be confirmed by pressing the following
keys:
1. Press (
).
2. Select [
設定
] using
or (
3. Select [
版本資訊
(
) or (
match the number of digits set in the barcode parameters.
Enter the correct number of digits.
The tape cutter was closed when you tried to print or feed
tape. Turn the P-touch off and then on again before
continuing. When tape is tangled in the cutter, remove the
tape.
The length of the label to be printed using the text entered
is longer than 1 metre. Edit the text so that the length of
the label is less than 1 metre.
The length of the label to be printed using the text entered
is longer than the length setting. Edit the text to fit within
the set length or change the length setting.
Please contact Brother customer service.
There is no conversion candidate. Please confirm the text
inputted and transform again.
Solution
or
, and then press (
).
] using
or
).
Cause/Remedy
)
, and then press
Advertisement
Table of Contents
