KitchenAid KOST100ESS Technical Education page 42

COMPONENT ACCESS
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
REMOVING THE BROIL ELEMENT.
At the front of the broil element is a broil guard
mounted with two screws. Remove the guard
(the front of the element will drop down a few
inches).
From the back of the oven, remove two broil
element mounting screws.
Pull the element into the oven to get the wiring
harness connections to enter the oven from the
back.
Remove the electrical connections but make sure
the harness does not exit the oven cavity.
4-8 Built-InSingle and Double Wall Ovens
n
REMOVING THE OVEN SENSOR
The Broil Element will need to be removed to
access the Sensor mounting bracket.
Remove the screw mounting the oven sensor and
pull the sensor into the oven far enough that
the sensor quick disconnect plug enters the
oven cavity.
Remove the electrical connection but make sure
the connector does not exit the oven cavity.
REMOVING THE CONVECTION ELEMENT
Remove the convection cover at the back of the
oven cavity by removing two mounting screws
at the top of the cover and releasing the cover
from two tabs at the bottom.
Locate and remove one convection element
mounting screw and release from a mounting
tab at the top of the element.
Pull the element into the oven far enough that
the element terminals enter the oven cavity.
Remove the electrical connections but make sure
the harness does not exit the oven cavity.