Porsche Boxster Technical Manual page 150

Boxster (986)
Body rear
Preparing the spare parts for installation
2
Cleaning the welding areas.
3 Inserting the cover panel, the trunk floor
panel and the end cross member into the
body and fitting into place.
Remove the factory-applied primer on the welding areas of
the spare parts -A; B; C; D; E; F; G- using the rotary
brush.
Remove underbody coating and paint layers, etc. from the
welding areas of the body with a hot-air gun or rotary
brush.
Insert the cover panel spare part at the rear panel of the
convertible-top compartment and fit into place.
Insert the trunk floor panel spare part at the side member
and fit into place.
Insert the end cross member and fit into place in the side
sections left and right. Install the rear lid, adjusting the con-
tours and gap dimensions at the left and right in relation to
the side sections. =:;. Rep. Gr. 5; Body gap dimensions
Install the lower part of the lid lock at the rear
=:;. Rep. Gr. 558619; Removing and installing lower part of
lid lock and check whether the upper part of the lock
engages in the lower part of the lock.
533655 Replacing rear cover panel
Printed in Germany -38, 2000
53-18 page 5
a533655x