Porsche Boxster Technical Manual page 134

Boxster (986)
Body rear
& Warning!
During body repairs, the following safety instructions and the general information and quality instruc-
tions must be followed. => Rep. Gr. 5; Safety instructions
rn Note!
.The accessories in the repair area should be removed, depending on the extent of the damage.
.All straightening work on the body in this area must have been completed before the damaged parts are
removed.
No.
Procedure Instructions
1
2
Separate the spot-weld connection between the end cross
member and the trunk floor panel -A- with the spot-weld
cutter.
Separate the connection between the end cross member
and the corner panel -D-, the inner side section connection
-C- and the inner light housing -8- left and right with the
spot-weld cutter.
Removing the accessories in the repair area
Separating the spot-weld connection
between the end cross member and trunk
floor panel
Separating the spot-weld connection
between the end cross member and the
side section connection, the corner panel
and the light housing
531655 Replacing end cross member
Printed in Germany -37 I 2000
53-16 page 3
a531655x