Eizo FDS1904 User Manual page 13

Setting Procedures
1.
Prepare to use analog screen adjustment patterns.
Load the "EIZO LCD Utility Disk" to your PC, and then open the "Screen adjustment pattern files".
Note
• For details and instructions on opening the "Screen adjustment pattern files", refer to the Readme.txt file.
2.
Perform the auto adjustment with the analog screen adjustment pattern
displayed.
●
To adjust flickering, screen position, and screen size automatically
Procedure
1. Display Pattern 1 in full screen on the monitor using the "Screen adjustment pattern files".
2. Choose "Screen" from the Adjustment menu, and press
3. Choose "Analog Adjustment" from the "Screen" menu, and press
4. Choose "Auto Adjustment", and press
The auto adjustment function works (the message "In Progress" appears) to adjust the flickering, screen
position, and screen size correctly.
When the auto adjustment is completed, a message appears. Select "OK" to confirm the new settings or
"Cancel"to restore the previous settings, and press
If the screen is not displayed correctly even after performing auto adjustment, perform the adjustments
according to the procedures on the following pages. If the screen is displayed correctly, go to
color gradation." (page
3.
Perform advanced adjustments for the following using "Analog Adjustment" of
"Screen".
Adjust the clock, phase and position, in this order.
●
To eliminate vertical bars
Procedure
1. Choose "Clock" from the "Analog Adjustment" menu, and press
2. Adjust the clock with
or
Press slowly so as not to miss the adjustment point.
3. Press to exit the adjustment.
When blurring, flickering or bars appear on the screen after adjustment, proceed to "To remove flickering or
blurring" to remove flickering or blurring.
.
15).
or to eliminate vertical bars.
.
.
.
.
Chapter 2 Adjusting Screens
"4. Adjusting
13