Fuse Replacement; Lamp Replacement - ADJ VIZI BEAM RXONE User Instructions

Vizi Beam RXONE
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized ADJ
Replacing with anything other than the specified part can damage
your unit and will void your manufactures warranty.
Warning:
If you continue to blow lamps or fuses, STOP using the
unit. Contact customer support for further instructions, you may have
to return the unit for servicing. Continuing to use the unit may cause
serious damage.

Fuse Replacement:

First unplug the power. The fuse holder is
located next to the PowerCon connection. Using a phillips head screw
driver unscrew the fuse holder. Remove the bad fuse and replace with
a new one.

Lamp Replacement:

lamp while the fixture is plugged in. Always disconnect the
main power and allow the unit at least 15 minutes to cool before
attempting to replace the lamp. Please see page 7 for important
information regarding the discharge lamp. See the next pages
for lamp replacement instructions. Be sure to follow the proper
handling procedures that deal with discharge lamps.
ADJ Products, LLC - www.adj.com - Vizi Beam RXONE Instruction Manual Page 36
Lamp & Fuse Replacement
service technician.
®
Caution! Never attempt to change the
Vizi Beam RXONE
ADJ Products, LLC - www.adj.com - Vizi Beam RXONE Instruction Manual Page 37
Lamp Replacement
Replacing the lamp is
relatively easy. Unplug the
unit from its power source.
Allow the unit 15 minutes
to cool down. Remove
the shell that says "Lamp
Access" on the rear. Start
by unscrewing the four
phillips screws that hold
the shell in place. Once
the screws are unscrewed
remove the shell. You will
now have access to the
lamp.