Gobo Replacement; Troubleshooting - ADJ X-COLOR LED PLUS User Instructions

X-Color LED GP™
The X-Color LED GP™ comes with a replaceable gobo. This gobo
can be interchanged at any time and allows you to customize your
system.
To replace gobo;
1. Remove the two phillips screws from the bottom of the unit.
2. Remove the access door, and unscrew the next two screws.
Once the screws have been removed pull out the gobo assembly.
3. Once the gobo assembly has been removed, remove the
retaining ring by pitching the ends inwards.
4. The gobo will now easily pop out. Remove and replace the gobo
with your desired replacement. Reinsert the retainer ring.
5. Slide the gobo assembly back into place, and replace the thumb
screw.
American DJ - www.americandj.com - X-Color LED GP™ Instruction Manual Page 15
®

Gobo Replacement

X-Color LED GP™
Locate and remove the unit's power cord. Once the cord has been
removed located the fuse holder located inside the power socket.
Insert a flat-head screw driver into the power socket and gently pry
out the fuse holder. Remove the bad fuse and replace with a new one.
The fuse holder has a built-in socket for a spare fuse be sure not to
confuse the spare fuse with active fuse.
X-Color LED GP™
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the
internal and external optical lenses and mirror should be carried out
periodically to optimize light output. Cleaning frequency depends on
the environment in which the fixture operates (I.e. smoke, fog residue,
dust, dew). In heavy club use we recommend cleaning on a monthly
basis. Periodic cleaning will ensure longevity, and crisp output.
1. Use normal glass cleaner and a soft cloth to wipe down the out-
side casing.
2. Use a brush to wipe down the cooling vents and fan grill.
3. Clean the external optics and mirror with glass cleaner and a soft
cloth every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth every
30-60 days.
5. Always be sure to dry all parts completely before plugging the unit
back in.
X-Color LED GP™
Trouble Shooting: Listed below are a few common problems that
you may encounter, with solutions.
No light output from the unit;
1. Be sure you have connected your unit into a standard 120v wall
outlet.
2. Be sure the external fuse has not blown. The fuse is located on
the rear panel of the unit.
3. Be sure the fuse holder is completely and properly seated.
Unit does not respond to sound;
1. Low frequencies (bass) should cause the unit to react to sound.
Tapping on the microphone, quiet or high pitched sounds may
not activate the unit.
American DJ - www.americandj.com - X-Color LED GP™ Instruction Manual Page 16
®
Fuse Replacement
Cleaning
Trouble Shooting