System Menu - ADJ VIZI BEAM RXONE User Instructions

Vizi Beam RXONE
Slave Mode -
This will let you set unit as a master or
slave in a master/slave configuration.
1. Press the MENU button until "Slave Mode" is displayed,
press ENTER. Either "Master", "Slave 1" or "Slave 2" will be
displayed.
2. Press the UP or DOWN buttons until your desired setting is
displayed, then press ENTER to confim.
NOTE: In a Master/Slave configuration you can make one
fixture the Master and then set the next fixture to "Slave 2", the
fixtures will now have contrast movement to each other.
DMX Last State
- This mode can be used as a precau-
tion mode, that in case the DMX signal is lost, the operating
mode chosen in the setup is the running mode the fixture
will go into when the DMX signal is lost. You can also set
this as the operating mode you would like the unit to return
to when power is applied.
1. Press the MENU button until "DMX State" is displayed, press
ENTER.
2. Either "Master/Slave", "Blackout", or "Last State" will be dis-
played. Choose an operating mode you would like the unit to
start up in when power is applied or the DMX signal is lost.
• Master/Slave - If the DMX signal is lost or power is applied, the
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the fixture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
ADJ Products, LLC - www.adj.com - Vizi Beam RXONE Instruction Manual Page 28

System Menu

Vizi Beam RXONE
Sound State
active mode.
1. Press the MENU button until "Sound State" is displayed, press
ENTER.
2. Either "On" or "Off" will now be displayed. Use the UP or
DOWN buttons to toggle between "On" and "Off".
3. Press ENTER to confirm your selection, the press and hold the
MENU button to activate.
Sound Sense
sensitivity of the sound active mode.
1. Press the MENU button until "Sound Sense" is displayed,
press ENTER.
2. Press the UP or DOWN buttons to adjust the sensitivity level.
The sensitivity level can be adjusted between 0 (the lowest) and
100 (most sensitive).
3. Press ENTER to set you desired level.
Pan Invert
1. Press the MENU button until "Pan Invert" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
Pan inversion, select "No" and press Enter.
Tilt Invert
1. Press the MENU button until "Tilt Invert" is displayed, press
ENTER. Either "Yes" or "No" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons
until "Yes" is displayed, press ENTER to confim. To deactivate
Tilt inversion, select "No" and press Enter.
- In this mode the unit will run in sound
- In this mode you can adjust the sound
- Pan Inversion
- Tilt Inversion
ADJ Products, LLC - www.adj.com - Vizi Beam RXONE Instruction Manual Page 29
System Menu