Replacing Batteries; Programming The Remote Control - Universal Remote Control UR2-211 Operating Manual

3

Replacing Batteries

Before you program or operate the remote
control, you must install two new AA
alkaline batteries.
STEP1 Removethebatterycompartment cover
fromthebackofyourremotecontrol.
STEP2 Check battery polarity carefully,
and install the batteries as shown
in the illustration below.
STEP3 Replace the battery
compartment cover.
4

Programming the Remote Control

*Note : In this section, when you are instructed to press a [DEVICE] button, that means you should press either the
CBL or TV button, depending on which device you are programming the remote to operate.
A. Quick Set-Up Method
A. Quick Set-Up Method
(Refer to the Section 5 Quick Set-up table of codes)
STEP1 Turn on the equipment you want to program. To program your TV, turn on the TV.