Universal Remote Control UR2-211 Operating Instructions

Operating Manual
For Easy Clicker
UR2-211
Universal Remote Control, Inc.
www.universalremote.com
OCE-0082E Rev 08 (14/03/14)
1
Introduction
This remote control is designed
to operate most Digital, Analog
Cable boxes, IPTV set top boxes
and TVs.
2
Replacing Batteries
Before you program or operate the
remote control, you must install
two new AA alkaline batteries.
STEP1 Remove the battery com-
partment cover from the
back of your remote control.
STEP2 Check battery polarity
carefully, and install the
batteries as shown in the
illustration below.
STEP3 Replace the battery com-
partment cover.
4

Programming the Remote Control

*Note : In this section, when you are instructed to press a [DEVICE] button, that means you should press either
the CBL or TV button, depending on which device you are programming the remote to operate.
A. Quick Set-Up Method
A. Quick Set-Up Method
(Refer to the Section B Quick Set-up table of codes)
STEP1 Turn on the component you want to program. To program your TV, turn on the TV.
3
Button Functions
STEP2 Press and hold the [
key for 5 seconds u
Device LED will blin
and stays on. Continu
the [DEVICE] key an
the number key ass
your brand in the Qu
up Code Table and
both [DEVICE] key
number key to save th
The Device LED w
twice to confirm that t
is stored.
STEP3 Point the remote cont
component.
STEP4 Press the power but
turns off, it is program
your component. If it
turn off, use th
Programmed 3-Dig
Method or Scanning M
Repeat the steps above
Macro Button
For future use
components (CBL, TV).
B. Quick Set-up Code T
B. Quick Set-up Code T
CBL
Quick Number
0 PACE DTA
1 SA/CISCO, SAMSUNG, PACE
2 MOTOROLA DIGITAL
3 MOTOROLA DTA
4 EVOLUTION DTA
5 CISCO IPTV
6 ADB IPTV
7 TECHNICOLOR
8 AMINO 140/540 IPTV
9 MOTOROLA IPTV
Manufacturer/Br