Aerco Benchmark 2.0 Installation, Operation & Maintenance Instructions Manual page 6

CONTENTS
Chapter 5 – MODE OF OPERATION
Para. Subject
5.1 Introduction
5.2 Indoor/Outdoor Reset Mode
5.3 Constant Setpoint Mode
5.4 Remote Setpoint Mode
5.5 Direct Drive Modes
Chapter 6 – SAFETY DEVICE TESTING PROCEDURES
Para. Subject
6.1 Testing of Safety Devices
6.2 Low Gas Pressure Fault Test
6.3 High Gas Pressure Test
6.4 Low Water Level Fault Test
6.5 Water Temperature Fault Test
6.6 Interlock Tests
6.7 Flame Fault Test
Chapter 7 – MAINTENANCE REQUIREMENTS
Para. Subject
7.1 Maintenance Schedule
7.2 Ignitor-Injector
7.3 Flame Detector
7.4 Combustion Calibration
7.5 Safety Device Testing
7.6 Burner Assembly Inspection
Chapter 8 – TROUBLESHOOTING GUIDE
Para. Subject
8.1 Introduction
ii
Page Para.
5-1 5.6 Boiler Management System
5-1 (BMS)
5-2 5.7 Combination Control System
5-2 (CCS)
5-3
Page Para.
6-1 6.8 Air Flow Fault Test
6-1 6.9 SSOV Proof of Closure Switch
6-2 6.10 Purge Switch Open During
6-2 Purge
6-2 6.11 Ignition Switch Open During
6-3 Ignition
6-3 6.12 Safety Pressure Relief Valve
Test
Page Para.
7-1
7.7 Condensate Trap
7-2 7.8 Shutting the Boiler Down For An
7-3 Extended Period of Time
7-3 7.9 Placing The Boiler Back In
7-3 Service After A Prolonged
7-3 Shutdown
Page Para.
8-1
Subject
Subject
Subject
Subject
5-1
Page
5-4
5-5
6-1
Page
6-4
6-5
6-5
6-6
6-6
7-1
Page
7-5
7-5
7-5
8-1
Page