To Preset Channels (Manual Search); Mft (Manual Fine Tuning) - Palsonic 6140G Owner's Manual

OPERATION
Tuning in (continued)
Use the MANUAL SEARCH function if desired channels can not be preset with the
AUTO SEARCH or if you would like to preset channels to specific position numbers one by one.
It is convenient to set the channel numbers to the same position numbers using MANUAL
SEARCH and SKIP functions.

To preset channels (Manual search)

Manual search
If AUTO SEARCH can not preset the desired channels, or you want to preset the desired channels one
by one with the preferred channel numbers, please make use of Manual search.
1.
Press the MENU button repeatedly to enter into the
select POSITION. Press the
to select a desired position number (from
0~255)
press the or
Note:
within 0.7 seconds. Press and hold the
for over 0.7 seconds to select a decimal number
2.
Press the
button to search channels from current channel to
higher channel (the screen displays glittering "
Press the
channel to lower channel (the screen displays glittering "
When a channel is located, the searching stops, this channel
is then memorised with the preset position number.
you can also make use of BAND selection to quicken the
Note:
searching process in your desired band. Press the
button moves the band to the next step in the sequence below.
3. When you want to store another channel at another position, repeat steps 1 & 2 above.
(PRESET) menu, or press the
button to select a channel number
or button to select SEARCH. Press the
button to search channels from current
VHFL VHFH
or button to
or button
or button
").
").
or
UHF
9
008
POSITION
BAND VHFL
SKIP OFF
SEARCH
MFT
AUTO MEMORY
lllllllllllll
lllllllllllllllllllllllllllllllll
POSITION 008
BAND VHFL
SKIP OFF
SEARCH
MFT
AUTO MEMORY
lllllllllllll
lllllllllllllllllllllllllllllllll
POSITION 008
VHFL
BAND
SKIP OFF
SEARCH
MFT
AUTO MEMORY
lllllllllllll
lllllllllllllllllllllllllllllllll