To Preset Channels (Manual Search) - Palsonic 5159P Owner's Manual

OPERATION
Tuning in (continued)
.
Use the MANUAL SEARCH function if desired channels can not be preset with the AUTO-
SEARCH or if you would like to preset channels to specific position numbers one by one.
.
It is convenient to set the channel numbers to the same position numbers using MANUAL
SEARCH and SKIP functions.

To preset channels (Manual search)

Manual search
If AUTO SEARCH can not preset the desired channels, or you want to preset the desired
channels one by one with the preferred channel numbers, please make use of Manual search.
1. Enter into POS.MEMORY menu, press the
select and highlight POSITION. Press the
select a desired position number (from 00~99).
Note: press the or
within 0.7 second. Press and hold the
0.7 second to select a decimal number.
2.
Press the or button to select and highlight SEARCH. Press
the button to search channels from current channel to higher
channel. Press the
channel to lower channel. When a channel is located, the
searching stops, this channel is then memorised with the preset
channel number.
you can also make use of BAND selection to quicken the
Note:
searching process in your desired band. Pressing the
button moves the band to the next step in the sequence below.
3. When you want to store another channel with another position, repeat steps 1 & 2 above.
button to select a channel number
or
button to search channels from current
VHFL VHFH
or button to
or button to
button for over
or
UHF
8
POS.MEMORY
POSITION 01
BAND VHFL
SKIP OFF
SEARCH DOWN
MFT DOWN
AUTO MEMORY
! ! ! ! ! ! . . . . . .
POS.MEMORY
POSITION 01
BAND VHFL
SKIP OFF
SEARCH DOWN
MFT DOWN
AUTO MEMORY
! ! ! ! ! ! . . . . . .
POS.MEMORY
POSITION 01
BAND VHFL
SKIP OFF
SEARCH DOWN
MFT DOWN
AUTO MEMORY
! ! ! ! ! ! . . . . . .