Programmable Feature Call - EnGenius DuraFon User Manual

ii. Start to receive the phone book, the LCD shows, "Get phone book from
Ext. # : xx."
iii. A beep is emitted when receiving each phone book.
iv. When the phone book is being received, a 2-digit countdown shows on
the LCD to indicate the phone book numbers that are pending.
Re: Since the phone book transfers through the wireless interface, it may
partially miss transmission if there is any interference.
11. To transfer phone book via web:
You can edit/store 50-phone book entries via the web interface. The base can be
used as the sending party.
a.
Place the receiving handsets to Receiving mode, by pressing
soft key follow by
b. Press "Transfer" button on the web interface of the base to send up to 50-
entries of the phone book.
Re: The handset will not update any phone book when it stores up to a
maximum of 50-entries.

Programmable Feature Call

1. If DuraFon-SIP base station is installed behind a PBX system, it is feasible to pre-
program some call features along with the PBX's feature code into the system.
2. Up to 10 most frequently used feature call codes can be pre-programmed.
3. Name and enter feature call codes:
a. Press
MENU
standby mode.
b. Press
4 , followed by
menu.
c. Press
ADD
entry.
d. Key in the name of the feature call, like editing a phone
book entry, i.e. "PBX Transfer."
Press SAVE
5 , 2 to enter Receiving mode. The LCD shows "Ready."
(Right) soft key while the handset is in the
4 to enter the "Feature Call "
(Left) soft key to add a new feature call
(Left) soft key to confirm.
~43~
OPTION (Right)
Empty
ADD