Candy DT-01220 Instruction Manual page 82

FLEXIBLE AREA
This area can be used as a single zone or as two different
zones, accordingly to the cooking needs anytime.
Flexible area is made of two independent inductors that can
be controlled separately. When working as a single zone,
the part that is not covered by cookware is automatically
switched off after one minute.
To grant a correct pan detection and a even heat distribution,
the cookware should be correctly placed:
- In the front or rear side of the flexible zone when the
cookware is smaller than 22 cm
- Anywhere with bigger cookware
As big zone
To activate the flexible area as a single big zone, simply press
the dedicated keys.
The power setting works as any other normal area.
If the pot is moved from the front to the rear part (or viceversa),
the flexible area detects automatically the new position,
keeping the same power.
Deactivation of the continuum zone
Resetting the power of the continuum zone or pressing
the continuum key again
As two independent zones
To use the flexible area as two different zones with different
power settings, press the dedicated keys.
The maximum power of cooking zones is
as follows:
Heating Zone
6
7
Flexible Area
8
9
R^[ WXel[ cWo lWho
j^[ cWj[h_Wb _j _i cWZ[ \hec
MehcWb
Beeij
1800
3000
1800
3000
3000
4000
1800
3000
1800
3 000
e j^[ i_p[ e\ j^[ fWd WdZ
WYYehZ_d] j
PT-10