Yamaha MAJESTY YP400A Owner's Manual page 95

Section E - Emissions Control System Warranty
(for applicable models only)
YAMAHA warrants to the CUSTOMER of a MOTORCYCLE
covered by this warranty with a displacement of 50cc or greater,
that the MOTORCYCLE is designed, built and equipped so as to
conform at the time of DELIVERY with all federal emissions
standards applicable at the time of manufacture and that it is free
from defects in materials and workmanship which would cause it
not to meet these standards within the periods listed immediately
below. Failures other than those resulting from defects in material
or workmanship, which arise solely as a result of owner abuse
and/or lack of proper maintenance, are not covered by this
warranty.
Engine Displacement Period
Under 50cc 6,000 km or 5 years,
whichever occurs first
50cc to 169cc 12,000 km or 5 years,
whichever occurs first
170cc to 279cc 18,000 km or 5 years,
whichever occurs first
280cc and over 30,000 km or 5 years,
whichever occurs first
Section F
This warranty is in addition to, and not a modification of, any
warranty required by the laws of any province of Canada.
Subject to any applicable sales or consumer legislation, the above
warranty is in lieu of any warranty or representation, expressed or
implied, including any warranty of performance, merchantability or
fitness for a particular purpose on the part of YAMAHA, and any
other obligation or liability on behalf of YAMAHA, and the above
warranty constitutes your sole remedy and the full liability of
YAMAHA. In no event shall YAMAHA be liable for special, incidental
or consequential damages howsoever caused, whether by
negligence or otherwise resulting directly or indirectly from the use
of the MOTORCYCLE, or the MOTORCYCLE having replacement
parts or the unavailability of replacement parts.
YAMAHA does not assume, or authorize any person to create or
assume for YAMAHA, any obligation or liability in connection with
the MOTORCYCLE or any part thereof distributed by YAMAHA.
Original Equipment Tires
Tires supplied as original equipment on your MOTORCYCLE are
warranted separately by the individual tire manufacturer or its
representatives. Generally speaking, this warranty covers defects in
workmanship and material.
If an adjustment becomes necessary, present your MOTORCYCLE
to your DEALER and have the DEALER contact the appropriate tire
manufacturer.
Storing your MOTORCYCLE
If your MOTORCYCLE is not to be used for 60 days or more, it
must be properly stored to ensure against deterioration. You should
consult your Owner's Manual for storage details, but WE
RECOMMEND THAT YOU HAVE AN AUTHORIZED YAMAHA
MOTORCYCLE DEALER PREPARE YOUR MOTORCYCLE FOR
STORAGE. His highly-trained staff have the experience and the
qualifications to do the job right.
YAMAHA cannot accept responsibility for damage to your vehicle or
personal injury resulting from negligence or lack of experience in
the preparation of your MOTORCYCLE for storage.
Pre-delivery Checklist
The DEALER has assembled and inspected the MOTORCYCLE
according to the following pre-delivery checklist prior to DELIVERY
to the CUSTOMER. (Some items may not be applicable to all
models.)
Appearance
• Check for and correct superficial damage or missing parts
Battery
• Fill with electrolyte
• Charge battery properly
• Check vent hose routing
Valves
• Check valve clearances
• Check cam chain tension
Spark plug(s)
• Check gap
Carburetor(s)
• Drain float bowl(s) before starting
• Check idle speed, synchronization, starter operation
Fuel line
• Check fuel hose routing and ensure that clamps are in proper
position
Oil levels
• Check engine oil, transmission oil, and final gear oil
Oil pump (2-stroke)
• Bleed oil pump
• Check oil pump settings (cable and minimum stroke)
Coolant
• Check coolant level in radiator and recovery tank
Cables
• Check for proper routing and free play on throttle, brake, clutch
Clutch
• Check operation
Brakes
• Check operation, free play, fluid level
• Check parking brake operation
Drive chain
• Check free play
Wheels
• Check tire pressures and wheel run out
• Check wheel nut torque
• Check spokes for proper tension
Steering system
• Check operation
10-6
CONSUMER INFORMATION
Suspension
• Check operation and adjustment
Drive select lever
• Check operation
Fittings/Fasteners
• Check all for loose or missing hardware
Electrical system
• Check all light and switch operations
• Check safety switches and horn for proper operation
• Check headlight aim
Ignition
• Check ignition timing
Final
• Check for and correct superficial damage or missing parts
• Test ride and check for any abnormal noise or function
2
3
4
5
6
7
8
9
10