Yamaha MAJESTY YP400A Owner's Manual page 24

Hide thumbs Also See for MAJESTY YP400A:
Table of Contents

Advertisement

INSTRUMENT AND CONTROL FUNCTIONS
the top segment and coolant tempera-
ture warning indicator flash, stop the
engine and let the engine cool. (See
page 7-38.)
1
2
3
4
5
NOTICE
Do not continue to operate the en-
6
gine if it is overheating.
7
Oil change indicator "OIL"
This indicator flashes at the initial 1000
8
km (600 mi), then at 5000 km (3000 mi)
and every 5000 km (3000 mi) thereafter
9
to indicate that the engine oil should be
changed.
After changing the engine oil, reset the
oil change indicator. (See page 7-14.)
If the engine oil is changed before the
oil change indicator comes on (i.e. be-
fore the periodic oil change interval has
been reached), the indicator must be
reset after the oil change for the next
periodic oil change to be indicated at
the correct time. (See page 7-14.)
The electrical circuit of the indicator can
be checked according to the following
procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Check that the indicator comes on
for a few seconds and then goes
off.
ECA10021
3. If the indicator does not come on,
have a Yamaha dealer check the
electrical circuit.
TIP
The oil change indicator may flash
when the engine is revved with the
scooter on the centerstand, but this
does not indicate a malfunction.
V-belt replacement indicator
"V-BELT"
This indicator flashes every 20000 km
(12500 mi) when the V-belt needs to be
replaced.
The electrical circuit of the indicator can
be checked according to the following
procedure.
1. Turn the key to "ON" and make
2. If the indicator does not come on,
"
Self-diagnosis device
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If a problem is detected in any of those
circuits, the multi-function display will
indicate an error code.
If the multi-function display indicates an
error code, note the code number, and
then have a Yamaha dealer check the
vehicle.
4-5
sure that the engine stop switch is
set to "
".
have a Yamaha dealer check the
electrical circuit.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents