Installation & Initial Startup - Mustek Power Must 424 Startup Manual

Installation & Initial Startup
NOTE: Before installation, please make sure nothing inside of package is
damaged. To protect your equipment from power failure, be sure that power
switch must be kept in the "ON" position. Following below steps to install your
UPS unit.
EN
Connect to Utility & Charging
Plug in the AC input cord to the wall outlet. For the best results, suggest to
charge the battery at least 4 hours before initial use. The unit charges its battery
while connecting to the utility.
Connect the Loads
Plug in the loads to output receptacles on the rear panel of the UPS. Simply turn
on the power switch of UPS unit, then devices connected to the UPS will be
protected by UPS unit.
CAUTION: NEVER connect a laser printer or scanner to the UPS unit. This may
cause the damage of the unit.
Connect Modem/Phone Line
Connect a single modem/phone line into surge-protected "IN" outlet on the rear
panel of the UPS unit. Connect from "OUT" outlet to the computer with phone
line cable.
Connect USB Cable
For the USB serial cable, just simply plug into the UPS and PC and it will be auto
detected. It will allow for unattended system shutdown for your operating system.
Turning On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by
pressing again the power switch. You may check the front LED indicators for the
status.
Cold Start Function
When the UPS is off and there is no power utility, it's still possible to cold start
the UPS unit to power the loads.
4