Table of Contents
Advertisement
gaS appLIaNCe INSTaLLaTION
Figure 30
gas Line plumbing detail
Outer Fireplace Wrap
Inner Fireplace Wrap
Side Brick
Hearth Brick
Gas Line Access Tube
CauTION: When using a gas appli-
ance, the fireplace damper must be
set in fully open position.
appLyINg deCOraTIve TrIM TO THe
FIrepLaCe
Do not allow the trim materials to extend closer than 3/8
inch to the vertical edges of the firebox opening if you plan
to equip the fireplace with glass doors.
The face of your fireplace may be left exposed or trimmed
with any noncombustible material such as brick, stone or
marble. If a trim is installed, be sure it is fastened snugly
to the face of the fireplace. A crack between the material
and the face of the fireplace could pose a fire hazard and
impair the proper operation of the fireplace. Blocking
the fireplace with framing and attaching the base to the
supporting floor will further reduce the possibility of such
a crack developing.
Wall ties should be fastened to the face of the fireplace
with sheet metal screws and placed in the mortar joints of
masonry trim.
87D0058
Maintain 1/2" Minimum Air Space
Clearance to Combustibles for
Gas Line Out to 4" From Side of
the Fireplace
Combustible Materials May Be Lo-
cated at Zero Clearance to Gas Line
Beyond 4" From Fireplace Side.
Repack Insulation Around
Gas Line Where it Passes
Through Gas Line Access
Tube for Proper Seal
SB50HB Series Woodburning Fireplace
Back Brick
Combustible material must not be installed below the top
spacers of the fireplace or overlap the sides of the fireplace
face. Seal the face of the fireplace to the surrounding wall
with non-combustible caulk or trim materials to prevent cold
air leakage around the fireplace.
The trim should not block or restrict in any way the flow of
air into the side air inlets in the face of the fireplace.
Be sure to provide the required floor protection as described
in a preceding section of this manual.
Combustible mantels and trim must be installed in
accordance with the National Fire Protection Association
- ANSI NFPA 211 Standard - Section 7-2.3.3.
Side Brick
Knockout
FP2232
27
Advertisement
Table of Contents
