Setting Option - Max ER-2500 Instruction Manual

SETTING OPTION

Press "OPTION" key to set "Melody" after inserting "Key-Card."
MELODY (CODE 01)
Set "Melody" of internal time signal. ER-2500R can control connecting time length to external
bell, buzzer or chime.
[ER-2500 or ER-2500E]
(Type of Melody)
Press or to select the desired number from the following table.
◆ Initial data=- - (Nothing)
Number
- -
1
2
1. ER-2500 can sound time signal by selecting the "1" or "2."
2. ER-2500R can control connecting time length to external bell from 1 to 60 seconds.
3. (When using external bell with ER-2500R)
◆ Select the "1" or "2" in Type of Melody setting.
◆ ER-2500R sounds both internal and external signal at the same time.
4. When pressing
(ER-2500R sounds Melody for time set in Connecting Time Length.
Adjust volume by Phillips screwdriver.
Example (In case of ER-2500R)
Melody= "1" (Original Melody), Connecting Time Length=15 seconds
Press "OPTION" key after inserting "Key-Card."
Current setting data is shown on the display.
Press or
Press to move the cursor to set Connecting Time Length.
Press or
Press to display CODE 02 as the next setting item.
(Type of Melody) (Connecting Time Length to the External Bell)
Melody
Nothing
Chime
Original Melody
If select the "- -(Nothing)," ER-2500R cannot sound external time signal.
When setting no sounds of internal signal, turn down the volume.
key, you can confirm melody for 10 seconds.
Procedure
until the display shows "2."
until the display shows "15."
[ER-2500R]
- 19 -
Display