Maintenance - EGO CH5500E Operator's Manual

CHARGING A HOT OR COLD BATTERY PACK
EN
If the battery pack is out of the normal temperature range, LED1 will shine red. When
the battery pack cools down to approximately 57°C or warms to more than 3°C, the
charger will automatically begin charging and the 4 LEDs will sequence normally.
DEFECTIVE BATTERY PACK OR CHARGER
If the charger detects a problem, LED1 will begin flashing red or all the LEDs
will turn off.
1. If registering as defective, remove and reinsert the battery pack in the charger.
If the LEDs still read "defective" a second time, try charging a different battery
pack.
2. If a different battery pack charges normally, dispose of the defective battery pack
(refer to the instructions in the battery pack manual).
3. If a different battery pack also indicates "defective", unplug the charger and wait
until the flashing LED1 goes out, then reconnect the plug to the power supply. If
LED1 on charger still display defective, the charge may be defective.
WALL-MOUNT HOLES
The charger has hanging holes for convenient storage (Fig.1). Install screws in the wall
76mm apart. Use screws sufficiently strong to hold the combined weight of the charger
and battery pack (approximately maximum 4.1kg.)
14
56V RAPID CHARGER — CH5500E

MAINTENANCE

WARNING:
To avoid serious personal injury, always remove the battery pack
from the tool when cleaning or performing any maintenance.
WARNING:
When servicing, use only identical EGO replacement parts. Use of
any other parts may create a hazard or cause product damage.
WARNING:
It is not recommended to use compressed dry air as a cleaning
method of the charger. If cleaning with compressed air is the only method to apply,
always wear safety goggles or safety glasses with side shields when cleaning the tool.
If the operation is dusty, also wear a dust mask.
WARNING:
if the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. to come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
WARNING:
When servicing, use only identical EGO replacement parts. Use of
any other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified service technician at an EGO
Service Center.
15
56V RAPID CHARGER — CH5500E
EN