General
IMPORTANT! Prevent unintentional
!
starting by removing the ignition cable
from the spark plug.
Handle
Assembly
1
Place the handlebar's tubular construction in direct
opposite to the lower part of the handlebar.
2
First, position the guide screw in the lower pipe in the
handle.
3
Then, center one of the holes for the fixing screw to
the hole in the handle.
4
Fit the screw, washer, and knob. Tighten the knobs
properly.
5
Use enclosed cable holder to secure cables to the
handle. Do not overstretch cables when mounting.
ASSEMBLING AND ADJUSTMENTS
Settings
Handle height
1
Loosen the lower knobs.
2
Dismantle the knob, washer, and screw.
3
Handle height can be set to 2 different positions,
Adjust to a suitable height with the fixing screw in one
of the two upper holes.
4
Fit the screw, washer, and knob.
5
Slide the knobs up towards the handle until they stop
and a click is heard.
–
English
71