Questions And Answers; Recommended Batteries; General Specifications - Gigaset a400 Manual

Specifications

Recommended batteries

Technology: Nickel-metal-hydride (NiMH)
Size: AAA (Micro, HR03)
Voltage: 1.2 V
Capacity: 400–800 mAh
The device is supplied with two approved batteries.
Base power consumption
In standby mode
- Charged handset in base
- Handset not in base
During a call

General specifications

DECT standard Is supported
GAP standard Is supported
(The Gigaset handset is only fully
functional on Gigaset bases)
Range Up to 300 m outdoors
Up to 50 m indoors
Base power supply 230 V ~/50 Hz
Environmental condi- +5°C to +45°C, 20% to 75% relative
tions in operation humidity
Standby time 220 hours
Talktime 20 hours
Operating time for 1.5
hours of calls per day
- Without Eco Mode+ 135 hours
- With Eco Mode+ 90 hours
Charging time in
charger 5.5 hours
12

Questions and answers

If you have any queries about the use of your tele-
phone, visit our website at
www.gigaset.com/service
for assistance 24/7. The table below contains a list of
common problems and possible solutions.
Problem
Nothing
appears in the
display.
approx. 0.7 W
< 0.4 W
approx. 0.5 W
No wireless
connection to
the base, Base
flashes in the
display.
You cannot
hear a ringer
melody/dial-
ling tone from
the fixed line
network.
Error tone
sounds after
system PIN
prompt.
PIN forgotten.
The connec-
tion always
terminates
after approx.
30 seconds.
Approval
This device is intended for connection to analogue
networks outside the EEA (with the exception of Swit-
zerland) depending on national type approval.
Country-specific requirements have been taken into
consideration.
We, Gigaset Communications GmbH, declare that this
device meets the essential requirements and other
relevant regulations laid down in
Directive 1999/5/CE.
A copy of the 1999/5/EC Declaration of Conformity is
available at this Internet address:
www.gigaset.com/docs
Cause Solution
The handset is not Press the end call key a
switched on. for approx.
5 seconds or place the
handset in the base.
The batteries are Charge or replace the
flat. batteries.
The handset is out- Move the handset
side the range of closer to the base.
the base.
The handset is not Register the handset
¢ page 9.
registered.
The base is not Check the mains con-
switched on. nector on the base
¢ page 3.
The phone cord Please always use the
supplied has not phone cord supplied or
been used or has ensure that the pin
been replaced by a connections are cor-
new cord with the rect when purchasing
wrong pin connec- from a retailer: 3-4
tions. assignment of tele-
phone leads/EURO
CTR37.
You have entered Reset the system PIN to
the wrong system the default setting
0000 ¢ page 10.
PIN.
All handsets are de-
registered. All settings
are reset. All lists are
deleted.
Repeater acti- Deactivate and
vated/deactivated reactivate the handset
¢ page 11. ¢ page 6.