Mh Series: Before You Begin; Mh Series: Explanation Of Controls - Branson 1800 Instruction Manual

- Do not place parts or containers directly on the bottom of the tanks; use a tray or wire to suspend
items. Direct placement can cause the units to fail.
- Do not allow the solution to drop more than 3/8 inch (1 cm) below the operating level line with heat
or ultrasonics on.
- Do not ever use alcohol, gasoline, or flammable solutions. Doing so could cause a fire or
explosion. Use only water-based solutions.
- Do not ever use mineral acids. These could damage the tank.
Failure to comply with these cautions will void your warranty.
Step Action
1 Select your cleaning solution.
2 Allowing for the volume of the parts you will be cleaning and leaving room for cleaning solution,
fill the tank with warm tap water to the operating level line.
3 Add cleaning solution the tank water.
4 Plug the unit unto a grounded outlet.
For maximum efficiency, refer to "Optimizing your Ultrasonic Bath", before proceeding.
5
If this is the first time you are running the unit, or if you have changed cleaning solution, you must
degas the solution. If not, skip to "Cleaning items (Treating samples)".

MH Series: Explanation of controls

MH Series Tower

MH Series: Before you begin

CAUTION
NOTE:
Electron Microscopy Sciences
1560 Industry Road Hatfield, PA 19440 P.O. Box 550
TEL: 215-412-8400 FAX: 215-412-8450
EMAIL: sgkcck@aol.com WEB: www.emsdiasum.com
10