JVC VN-H37U SERIES Instructions Manual page 11

No. Item
Record Status
③
Recording
④
image quality
Constant
Alarm
Starts and stops recording to an SD card.
[Set values : ON, OFF]
[Status : No Recording, Recording]
This is only enabled when the SD card status is "Use" and the format status is
"Format complete".
When recording, the status changes to [Recording]. When recording is stopped,
the status changes to [Stopped]. When only alarm recording is selected, the
status becomes [Recording] when the alarm is engaged, and [Stopped] when
nothing is detected.
Check "ON" and check one of the available settings in "Recording image quality
settings" to begin continuous-loop recording to the SD card with the selected
encode settings.
Starts continuous-loop recording to the SD card with the selected recording
quality.
If you push [OK] when the encoding setting has not been set, the "Select an
encoding setting." dialog is displayed and recording does not start.
Select "OFF" and click the [OK] button to stop recording.
For specifying the mode for recording to the SD card.
You can select either "Constant", "Alarm", or both settings.
Select this by adding a check to the checkbox for the desired mode.
To change the recording image quality, select "OFF" for ③ Record Status, push
the [OK] button to stop recording, and then configure settings.
If no check is added to either box and you set recording to "ON" and press the
[OK] button, the "Set the recording mode." dialog is displayed and recording does
not start.
Memo：
When the record status is "ON", the setting for Recording image quality cannot
be changed.
Constantly records to the SD card.
If all the free space on the SD card is used, recording will continue by deleting
from the oldest recording data to allocate recording space.
SD card recording is performed when conditions set for the alarm setting items
are met. The alarm event recording interval for when an alarm is triggered is from
60 seconds before the trigger (pre-trigger) to 60 seconds after the trigger
(post-trigger), for a total of 120 seconds.
Alarm recording-related setting items are displayed when "Alarm" is selected.
Memo：
Even if another trigger is detected within 60 seconds of the first trigger, it will
not register in the event list.
If another trigger is detected during alarm recording, recording is extended 60
seconds from the original end point.
If less than 60 seconds have passed since video recording was initially started,
the pre-trigger time will be less than 60 seconds.
Description
* The [Set values] in bold letters are factory defaults.
11