Panasonic WJ-ND300A/G Setup Instructions page 72

I File Name
Perform the settings for the rules about the file name to
be sent.
Select whether to "TIME & DATE BASE" or "SERIAL
NUMBER".
I Interval
Enter a number for transmission interval. Enter a num-
ber (1-1440) for transmission interval, and select
whether it will be "s" (seconds) or "m" (minutes) for the
interval unit.
I Channel to Send
Select a camera channel from which images will be sent
periodically. Images from the checked camera channel
will be sent to the FTP server.
Note:
When the image compression method of the camera
selected for a camera channel is "MPEG-4", the
images will not be sent.
FTP Send by Alarm
Perform the following settings to send images recorded
in the location where an alarm occurred. Perform the
settings to determine whether or not to send images
recorded in the location where an alarm occurred to the
FTP server using the timetable (page 57).
I Server Directory
Enter a directory of the server. Enter up to 255 alphanu-
meric characters. The available characters are the char-
acters listed below except (&*:<>?\ | ~ blank (space)).
Note:
The following alphanumeric characters can be
entered.
A B C D E F G H I J K L M N O P Q R S T U V W X
Y Z a b c d e f g h i j k l m n o p q r s t u v w x y z 0 1
2 3 4 5 6 7 8 9 ! " # $ % ' ( ) + , - . / ; = @ [ ] ^ _ ` { }
72
I Duration-Pre*
Select the duration of the images recorded by pre-event
recording to be transmitted from the following.
OFF/1 s - 10 s (in 1-second interval)
Important:
Images recorded by pre-event recording will not be
transmitted when pre-event recording is not to be
performed. Perform pre-event recording to transmit
images recorded by pre-event recording. Refer to
page 54 for further information about pre-event
recording settings.
I Duration-Post*
Select the duration of the images recorded by post-
event recording to be transmitted from the following.
OFF/1 s - 10 s (in 1-second interval)
Note:
It is possible to transmit images recorded by an
emergency recording to an FTP server. Recorded
images to be transmitted are as follows:
• Camera channel: Camera channel from which
images were recorded by an emergency record-
ing
• Recording duration: For the duration selected for
"Duration-Post" on the "FTP Setup" menu from
the time when the emergency recording started
• Directory where recorded images are to be trans-
mitted: The directory designated for "Server
Directory" of "Ftp send by alarm" on the "FTP
Setup" menu
*: When the image compression method of the camera
for a camera channel is "MPEG-4", the recording
duration of the recorded data may not be exactly
same as set recording durations for both the pre-
event recording and the post-event recording.
I Alter Detect
Select ON or OFF to determine whether or not to attach
an alteration detection code to recorded images to be
transmitted using the viewer software when an alarm
occurs.