GEAppliances GTL27 Owner's Manual And Installation Instructions page 25

Installation Instructions
[] REHANG THE REFRIGERATOR DOOR
Lower the refrigerator door onto the bottom
hinge pin,
Plastic
Screw the two screws into the center hinge location on
the left side with a 5/16" socket and ratchet,
Straighten the door and place the center hinge pin into
the opening on top of the door, Remember to include
the washer,
Move the door into place, so you can align the center
hinge bracket over the center hinge holes on the left
side, Insert and tighten the two screws with a 5/16"
socket and ratchet,
NOTE: Ensure the washer is in place on top of the hinge
pin,
.... °.......
i
i -J ......
Plastic Washer ----_
Hinge
Center Hing
Bracket d_ _ _
Refrigerator Door
@ REHANG THE FREEZER DOOR
Lower the freezer door onto the center hinge pin,
Be sure the washer is in place,
Hinge Pin
Washer
Lift the top hinge so the pin fits into the door socket,
Support the door on the handle side and make sure the
door is straight and the gap between the doors is even
across the front, While holding the door in place, tighten
the top hinge screws,
25
rfa
ADJUST THE DOORS
(IF NEEDED)
If the freezer door is too high:
Remove the hinge
cover on top of the
freezer door and
loosen the four
screws with a 5/16"
socket and ratchet,
Replace the hinge
cover,
1, Remove
the hinge
cover on
top of the
freezer door
and loosen
the four
screws with
a 5/16"
socket and
ratchet,
2, Loosen the
two center
If both doors are too high:
%
Loosen screws, 5/16"
Loosen
screws and
slide left to
lower doors,
hinge screws with a 5/16" socket and ratchet,
3, Slide the center hinge to the left to lower
the doors,
4, Fully tighten all screws and replace top hinge cover,
If both doors are too low:
1, Remove the
hinge cover
on top of
the freezer
door and
loosen the
_
four screws
with a 5/16"
socket and t
ratchet,
2, Loosen the
two center
hinge screws
%
Loosenscrews, 5/16"
5/16"
slide right
to raise
doors,
with a 5/16" socket and ratchet,
3. Slide the center hinge to the right to raise
the doors,
4, Fully tighten all screws and replace
top hinge cover,
NOTE; Save the door spacer,
Doors may settle with use,
Door Spacer