Precor 9.23 Service Manual page 46

9. Set the safety switch in its mounting position on the replacement display face and fasten it
with the screws removed in step 7.
10. Set the upper PCA in its mounting position in the replacement display face and fasten it with
the hardware removed in step 8. Connect the keypad cable to the JK6 connector, safety
switch cable to the JK7 connector and the user 1/2 keypad cable to the JK10 connector of
the upper PCA.
11. Set the console rear cover in its mounting position on the display face and fasten it six
screws removed in step 5.
12. Connect the data cable to the JK8 connector on the console and the heart rate cable (9.27
only) to the JK5 connector on the console. See Diagram 5.1.
13. Set the console in its mounting position on the backplate and fasten it with the screws
removed in step 3.
14. Check treadmill operation per Section 3.
9.23, 9.27 Treadmill
Page 46