Handle Bar And Handle Bar Stem; Adjusting Height; Ahead" Stem; Brake - Lindsey-west bicycle Pedelec Operating Instruction

Handle bar and handle bar stem

The handle bar can be adjusted as follows:
After a fall on the handle bar, you must
replace the handle bar and stem. Invisible
micro cracks can lead to breakage and
therefore, pose a risk of falling!

Adjusting height:

Loosen the nut or inner hexagon bolt of the
expander bolt (Figure, pos.1)
Loosen the bolt with a gentle hammer blow
and adjust the correct handle bar height.
Tighten the expander bolt finally.
Please pay attention to the marking, which
should under no circumstance project out of
the control tube. Danger of breaking – and
therefore, risk of falling!
Frequent re-adjustments of the seat can leave
permanent scratches on the surface of the seat
support due to mechanical action. These dam-
ages falls under normal wear and tear, and does
not constitute a case of materials defect liability.
Adjusting the inclination of the handle bar:
Loosing the joint (see Figure, pos. 2)
Rotate to the correct position
Tighten the joint
Operating Instruction Pedelec with Lithium ion battery pack
Angular adjustment of handle bar stem:
This stem offers more flexibility in adjusting the
handle bar position:
Adjustment:
Loosen the screw joint.
Rotate the handle bar to the desired position.
Tighten the screw joint.

„Ahead" Stem

This front end cannot be height-adjusted!

Brake

The brake system must be checked before each
ride. Only the dealer should be entrusted with the
job of adjusting the brakes. Readjustment of the
brakes is required when you observe an increas-
ing idle travel of the hand brake lever.
The same comes closer and closer to the handle
bar grip due to the wear and tear of the brake
rubber (shoe). Regular readjustment is necessary.
The brake rubbers are parts subjected to wear
and tear and they do not constitute a materials
defect liability.
35 35 GB