Statistics Config - Slant/Fin CHS-85 Instructions Manual

CHS Series

2.4.4.3 Statistics Config

Statistics Config – sub-menu screen displays the
number of burner and pump cycles, as well as burner
run time. Use the up and down (▲▼) buttons to
navigate the menu options; when the desired option is
highlighted select by pressing the "OK" button.
Pump cycle counts can be reset by the installer, for
example when a circulator is replaced.
Burner cycles and Burner run
time counters cannot be reset.
Table 2-15 Statistics Configuration Parameters
Parameter Description
Burner cycle Number of burner cycles on controller. Not resettable by the installer. Range 0 to
count 999,999.
Burner run time Total number of hours of burner operation. Range 0 to 999,999 hours.
Boiler pump
Number of Boiler pump (Pump B) cycles since last reset. Range 0 to 999,999.
cycle count *
CH pump cycle
Number of CH pump (Pump C) cycles since last reset. Range 0 to 999,999.
count *
DHW pump
Number of DHW pump (Pump A) cycles since last reset. Range 0 to 999,999.
cycle count *
* = Password protected
Figure 2-21 Statistics Configuration Screen
Controller and Display
Statistics Config
Burner cycle count
Burner run time
Boiler pump cycle count
CH pump cycle count
DHW pump cycle count
│
Slant Fin Corp.
29
7 hour
75
56
74
Factory Settings
0
0 hour
0
0
0
23