Servicing The Battery - Toro 07359 Operator's Manual

Hide thumbs Also See for 07359:

Operator's manual (48 pages)

Operator's manual (52 pages)

Table Of Contents

Table of Contents

Enlarged version

Replacing the Bulbs

CAUTION

The halogen bulbs become extremely hot when in

operation. Handling a hot bulb can cause severe

burns and personal injury.

Always all enough time to for the bulbs to cool

before replacing them. Use care whenever handling

the bulb.

CAUTION

Any surface contamination can damage the

headlight bulb and leading to its failure or explosion

creating a serious safety hazard.

Head light lamps should be handled without

touching the clear quartz, either by using a clean

paper towel or carefully holding the base.

Specification: See your Parts Catalog.

1. Disconnect the electrical harness from the bulb

housing on the back of the lamp.

2. Remove the bulb assembly by turning it 1/4 turn

counter clockwise and moving it rearward, out of the

lamp housing.

3. Remove the bulb from the base taking care not to

touch the halogen quartz.

4. Install a new bulb on the base. Use a paper towel

to grasp the new bulb with handling it to avoid

contaminating the surface.

5. Insert the new bulb and assembly into the headlight

housing and secure by turning it 1/4 turn clockwise to

lock it in place.

6. Connect the electrical harness.

Replacing the Headlight

When removing or replacing the headlight assembly,

disconnect the wiring harness to the bulb assembly if the bulb

is to be removed with the lamp.

1. Remove the speed clips and washers securing the

headlight in place. Retain all parts.

2. Remove the headlight assembly by moving it forward

through the opening in the front bumper (Figure 27).

1. Headlight

2. Opening in front end

3. Headlight bulb assembly

3. Install the new headlight through the opening in the

bumper (Figure 27). Ensure the adjustment posts are

lined up with the holes in the mounting bracket in the

bumper.

4. Secure the headlight assembly with the washers and

speed clips removed previously.

5. Attach the headlight to the wire harness removed

previously.

6. Adjust the headlights to direct the beams to the desired

position.

Adjusting the Headlights

Use the following procedure to adjust the headlight beam

position whenever a headlight assembly is replaced or

removed.

1. Turn the ignition key to the On position and turn on

the headlights.

2. At the headlight assembly, use the fasteners to pivot the

headlight assembly and affect the cast beam position.