Table of Contents
Advertisement
Lubrication
Lubricate all of the bearings and bushings every 100 hours
or once a year, whichever occurs first. Grease them more
frequently when using the vehicle for heavy-duty operations.
Grease Type: Number 2 General Purpose Lithium Base
Grease
Adding Grease
Service Interval: Every 100 hours
1. Wipe the grease fitting clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
The grease fittings are located at the four tie rod ends
(Figure 20) and the two king pins (Figure 21).
Figure 20
Left side shown
1. Grease fitting
Figure 21
Left side shown
1. Grease fitting
2. Tie rod
Engine Maintenance
Servicing the Air Cleaner
Check the air cleaner body for damage which could possibly
cause an air leak. Replace a damaged air cleaner body.
Ensure the cover is sealing around the air cleaner body.
Air Cleaner Filter: Inspect after every 100 operating hours;
replace after every 200 hours or sooner if dirty or damaged.
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Removing the Filter Element
1. Pull the latch outward and rotate the air cleaner cover
counterclockwise (Figure 22).
2. Remove the cover from the air cleaner body.
3. Gently slide the filter out of the air cleaner body
(Figure 22) to reduce the amount of dust dislodged.
Avoid knocking the filter against the air cleaner body.
1. Dirt ejection port
2. Cover
4. Inspect the filter and discard it if it is damaged.
Installing the Filter Element
Service Interval: Every 200 hours
Important: To prevent engine damage, always operate
the engine with the complete air cleaner assembly
installed.
Note: Cleaning of the used element is not recommended
due to the possibility of damage to the filter media.
1. Inspect the new filter for shipping damage, checking
the sealing end of the filter and the body. Do not use
a damaged element.
2. Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister. Do not
apply pressure to the flexible center of the filter.
23
G017194
Figure 22
3. Latch
4. Air filter
Advertisement
Table of Contents
