Maintenance; Recommended Maintenance Schedule(S) - Toro 07359 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Yearly
Important: Refer to your Engine Operator's Manual for additional maintenance procedures.
Maintenance Procedure
• Check the condition of the drive belt.
• Change the engine oil.
• Check the engine oil.
• Check the tire pressure.
• Check the transmission oil level.
• Check gear shift operation.
• Inspect the primary drive clutch.
• Check the radiator coolant level.
• Check the brake fluid level.
• Check the battery cable connections for wear or damage.
• Check the battery electrolyte level.
• Grease the bearings and bushings.
• Check the operation of the Neutral gear shift position.
• Inspect the condition and wear of the tires.
• Torque the wheel lug nuts to 80-90 ft-lb (108-122 N-m).
• Check the front wheel toe-in and camber.
• Clean the engine cooling areas (twice as often in special operating conditions; refer
to Maintaining the Vehicle under Special Operating Conditions).
• Inspect the brakes.
• Change the engine oil. (twice as often in special operating conditions; refer to
Maintaining the Vehicle under Special Operating Conditions)
• Change the oil filter. (twice as often in special operating conditions; refer to
Maintaining the Vehicle under Special Operating Conditions)
• Replace the air filter element.
• Clean the primary drive clutch (more often in dusty or muddy conditions).
• Check the parking brake operation.
• Check the condition and tension of the drive belt.
• Inspect the fuel lines and connections.
• Replace the fuel filter.
• Change the transaxle fluid.
• Change the radiator coolant.
• Change the brake fluid.
• Complete all yearly maintenance procedures specified in the Engine Operator's
Manual.
20