Power Trim And Tilt Switches (Twin Type); Trim Tab With Anode - Yamaha F225 Owner's Manual

Components
1
1. Power trim and tilt switch
EMU35160
Power trim and tilt switches (twin
type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch " " (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
UP
1
DN
1
1. Power trim and tilt switch
On the twin engine control, the switch on

the control grip controls both outboard mo-
tors at the same time.
For instructions on using the power trim

and tilt switches, see pages 64 and 66.
33
UP
DN
ZMU07151
" (up) trims the
UP
ZMU05835
DN
EMU26244

Trim tab with anode

EWM00840
WARNING
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side "A"
in the figure. If the boat tends to veer to the
right (starboard side), turn the trim tab end to
the starboard side "B" in the figure.
ECM00840
NOTICE
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it
will become ineffective as an anode.
1
1. Trim tab
2. Bolt
3. Cap
3
2
1
ZMU07152