Customer Service; Technical Data; Installation; Ventilation Requirements - Proline PLC102 User Manual

16
Problem

Customer Service

If your appliance is still not working properly
after making the above checks, contact the
nearest service centre.
To obtain fast service, it is essential that
when you apply for it you specify the model

TECHNICAL DATA

Dimensions Height × Width × Depth (mm):
850 × 550 × 593
Rising Time 26 hours

INSTALLATION

Positioning
Warning! If you are discarding an old
appliance that has a lock or catch on
the lid, you must ensure that it is made
unusable to prevent young children
being trapped inside.
Important! The appliance shall have the
plug accessible after installation.
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar), but for
optimum performance install this appliance
at a location where the ambient tempera-
ture corresponds to the climate class indi-
cated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C

Electrical connection

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
Possible cause
The thermostatic control is not
on
There is no voltage in the mains
socket (try to connect another
appliance into it)
and serial number of your appliance which
can be found either on the guarantee certifi-
cate or on the rating plate located on the
external right side of the appliance.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.

Ventilation requirements

1. Put the freezer in horizontal position on
2. Make sure that the clearance between
3. Make sure that the clearance between
The airflow behind the appliance must be
sufficient.
Solution
Check setting of thermostatic
control
Call an electrician
Further technical information are situ-
ated in the rating plate on the external
right side of the appliance.
a firm surface. The cabinet must be on
all four feet.
the appliance and rear wall is 5 cm.
the appliance and the sides is 5 cm.