Table of Contents
Advertisement
Back to Contents Page
Display
Dell Studio™ 1557/1558 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Hinges
Display Assembly
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
inside the computer.
Removing the Display Assembly
1. Follow the instructions in
Before You
2. Remove the base cover (see
3. Disconnect the antenna cables from the Mini-Card(s).
4. Lift the antenna cables from the securing tabs and release them from the routing channel.
1
securing tabs
5. Remove the two screws that secure the display assembly from the bottom of the computer.
6. Remove the center control cover (see
7. Remove the keyboard (see
Begin.
Removing the Base
Cover).
2
antenna cables
Removing the Center Control
Removing the
Keyboard).
Before Working Inside Your
Cover).
Computer) before working
Advertisement
Table of Contents
