Removing The Processor Module; Replacing The Processor Module - Dell Studio 1557 Service Manual

Hide thumbs Also See for Studio 1557:
Table of Contents

Advertisement

Back to Contents Page
  Processor Module
Dell Studio™ 1557/1558 Service Manual 
  Removing the Processor Module
  Replacing the Processor Module
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on the back of the computer).
 
CAUTION:
To prevent intermittent contact between the ZIF-socket cam screw and the processor when removing or replacing the processor, press
to apply slight pressure to the center of the processor while turning the cam screw.
 
CAUTION:
To avoid damage to the processor, hold the screwdriver so that it is perpendicular to the processor when turning the cam screw.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
inside the computer.
 Removing the Processor Module
 
1. Follow the instructions in
Before You
 
2. Remove the processor heat sink (see
 
3. To loosen the ZIF socket, use a small, flat-blade screwdriver and rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.
1 ZIF-socket cam screw 2 ZIF socket
 
CAUTION:
To ensure maximum cooling for the processor, do not touch the heat transfer areas on the processor thermal-cooling assembly. The
oils in your skin can reduce the heat transfer capability of the thermal pads.
 
CAUTION:
When removing the processor module, pull the module straight up. Be careful not to bend the pins on the processor module.
 
4. Lift the processor module from the ZIF socket.
 Replacing the Processor Module
Begin.
Removing the Processor Heat
Sink).
Before Working Inside Your
Computer) before working

Advertisement

Table of Contents
loading

Table of Contents