Table of Contents
Advertisement
Indication
"A" and "011" alternate on the copy quantity
display.
"A" and "040", "041" or "043" alternate on the
copy quantity display.
The Add Toner indicator flashes.
"AP" appears on the copy quantity display.
"PF" appears on the copy quantity display.
"E07" appears on the copy quantity display.
"E30" appears on the copy quantity display.
An error message will automatically be printed out. Turn the main switch OFF
and ON.
If this indication appears, the copier initializes the data to remedy the error. Make
the specifications setting (F29 Inch/metric specifications setting) before using the
copier again.
If the same indication appears again, print a user status report and contact your
service representative with the details on the report.
The error message is as follows:
"Default data was initialized. Need initial setting to use the machine. Input F29:
User Code. cf. User manual."
When you installed the memory copy board/DIMM, it was not installed correctly.
Check the installation of the memory copy board/DIMM and turn the main switch
OFF and ON. If the same indication appears when the memory copy board/
DIMM is installed correctly, remove the memory copy board/DIMM, print a user
status report and contact your service representative with the details on the
report.
Copying is still possible for some time with the indicator flashing but it will
eventually be disabled. Replace the toner container and waste toner tank as
soon as possible.
Toner is being replenished inside the copier. Wait a few minutes.
* Although the lamp under the platen may remain lit while "AP" is displayed, it is
not a problem.
• A paper misfeed occurred in the drawer of the flashing indicator. Remove the
misfed paper.
• The drawer of the flashing indicator is not inserted correctly. Close the drawer
securely.
• There is no paper in the drawer of the flashing indicator. Load paper.
The set paper size is different from that of the paper used. Check the paper size
setting and the actual paper size, and set the paper size to the size of the actual
paper or use a paper of the set size.
Installation may not have been performed correctly. Install the copier again by
referring to the installation manual.
CHAPTER 7 WHEN A PROBLEM OCCURS
Action
Page
6-6
6-7
6-1
6-7
3-7
––
7-4
3-1
3-3
6-2
6-3
6-7
––
7-2
Hide quick links:
Advertisement
Table of Contents
