power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on.
c) When battery pack is not in use, keep it away 10. Do not touch the bit during or immediately after from other metal objects, like paper clips, coins, operation. The bit becomes very hot during operation keys, nails, screws or other small metal objects, and could cause serious burns.
1. When the battery power remaining runs out, the motor REGARDING LITHIUM-ION BATTERY stops. TRANSPORTATION In such a case, charge it up immediately. 2. If the tool is overloaded, the motor may stop. In this When transporting a lithium-ion battery, please observe the case, release the switch of tool and eliminate causes of following precautions.
SPECIFICATIONS Switching ON The specifi cations of this machine are listed in the Table on Switching OFF page 8. NOTE Due to HITACHI’s continuing program of research and Disconnect the battery development, the specifi cations herein are subject to change without prior notice. Clockwise rotation CHARGING Counterclockwise rotation...
● Regarding the temperatures and charging time of the MOUNTING AND OPERATION battery. The temperatures and charging time will become as Action Figure Page shown in Table 2. Removing and inserting the Table 2 battery Charger Charging UC18YFSL Battery Remaining battery indicator Charging voltage 14.4 –...
NOTE Storing lithium-ion batteries. Make sure the lithium-ion batteries have been fully charged before storing them. Prolonged storage (3 months or more) of batteries with a low charge may result in performance deterioration, signifi cantly reducing battery usage time or rendering the batteries incapable of holding a charge.
Page 8
DH18DBL DH18DBQL 18 V 0 – 1050 /min 0 – 3950 /min 26 mm φ max 13 mm φ max 27 mm φ max 3.6 kg 3.9 kg – DH18DBL (NN) – – – – – DH18DBQL (NN) – – –...
Need help?
Do you have a question about the DH 18DBL and is the answer not in the manual?
Questions and answers