Advertisement
Adjust the spark protection guard to within < 2mm of the grinding wheel.
As the wheel wears down, the spark guard must be re-adjusted.
Mount the bench grinder:
To prevent the grinder from moving during operation, it must be securely mounted to a work bench or
stand.
MAIN CONNECTION
Do not connect bench grinder to the power source until all assembly steps have been
completed. The motor is designed for operation on the voltage and frequency specified. The mains
voltage must comply with the information on the machine licence plate. Normal loads will be handled
safely on voltages not more than 10% above or below specified voltage. Running on voltages, which
are not within range, may cause overheating and motor burnout. Heavy loads require that voltage at
motor terminals be not less than the voltage specified on nameplate.
Mains connection and any extension cords used must comply with applicable regulations.
Connections and repairs to the electrical equipment may only be carried out by qualified electricians.
Properly Ground Outlet
2-Prong Plug
Improper connection of equipment grounding conductor can result in the risk of electrical shock.
Equipment should be grounded while in use to protect operator from electrical shock.
- Check with a qualified electrician if you do not understand grounding instructions or if you are in doubt
as to whether the tool is properly grounded.
- This tool is equipped with an approved cord rated at 230V and a 2- prong grounding type plug for you
protection against shock hazards.
7
Advertisement
