Advertisement
Adjusting the tool rest
As the wheel wears down, the tool rest must be re-adjusted to maintain a maximum 2mm clearance.
Loosen screws (A) to adjust.
MAINTENANCE AND INSPECTION
Make all machine adjustments or maintenance with the machine unplugged from the power
source.
Maintenance, cleaning and repair work may only be carried out after the machine is protected
against accidental starting by pulling the mains plug.
Repair and maintenance work on the electrical system may only be carried out by a qualified
electrician.
Clean the machine regularly.
All protective and safety devices must be re-attached immediately after completed cleaning, repair and
maintenance work.
Defective safety devices must be replaced immediately.
Cleaning:
Regularly clean the machine housing with a soft cloth preferably after each use.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammoniac water, etc. These solvents may damage the
plastic parts.
10
Advertisement
