Assembly - Husqvarna LTH1797 Operator's Manual

Your new tractor has been assembled at the factory with
the exception of those parts left unassembled for
shipping purposes.
TO REMOVE TRACTOR FROM
CAR TON
UNPACK CARTON
• Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRAC TOR
FROM SKID
ATTACH STEERING WHEEL (See Fig. 1)
• Remove locknut and large flat wash er from steering
shaft.
• Position front wheels of the tractor so they are pointing
straight forward.
• Slide the steering sleeve over the steering shaft.
• Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
• Secure steering wheel to steering shaft with locknut
and large flat wash er pre vi ous ly removed. Tight en
securely.
• Snap steering wheel insert into cen ter of steering
wheel.
• Remove protective materials from tractor hood and
grill.
UNASSEMBLED PARTS
Steering
Wheel

ASSEMBLY

(1) Oil Drain Tube
Key
(2) Keys
Steering
Boot
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLL OFF SKID.
STEERING
WHEEL
STEERING
BOOT
STEERING
SHAFT
5
Slope Sheet
Steering
Extension
Shaft
Steering Wheel
Adapter
STEERING WHEEL
INSERT
BOLT
LOCKWASHER
LARGE FLAT WASHER
STEERING
WHEEL
ADAPTOR
07592
FIG. 1