Q-17: Can I Mount Ax-Tfrs On Walls, Poles Or In Towers - Optex AX-100TFR Series Frequently Asked Questions Manual

AX-100/200TFR series
Frequently Asked Questions (FAQ's)

Q-17: Can I mount AX-TFRs on walls, poles or in towers?

A-17: Yes, you can. It is also possible to mount two AX-TFRs on a same pole,
back to back. When you mounting an AX-TFR in a beam tower, an optional
unit "MP-4" (indicated in a picture below) is required. MP-4 includes tamper
bushings for LED termination.
Wall mount Pole mount Pole mount Tower in-mount
(Single detector) (Two detectors) MP-4 (Option)
required
Metal Plates Tamper Bushings
MP-4 (Optional kit)
Important notes:
> The switch selection cannot be recognized with the tamper bushing
inserted. Remove the tamper bushing before selecting a function using the
switch.
> After completion of the settings, be sure to insert a tamper bushing and
please check that all LEDs are turned OFF.
> Monitor Jack Output becomes disabled when tamper bushing inserted.
> When inserting the tamper bushing, reception indicators for beam
alignment will be disabled. Please complete the alignment tuning before
inserting the tamper bushing.
[For installation instruction, please refer to P.3-7 of the instruction manual.
P.12: SPECIFICATION describes more about the MP-4.]
P.9
All rights reserved by OPTEX Co., Ltd.